I've built a circuit that is supposed to shine certain number LEDs depending on the resistance of a resistor in the circuit (R1). I did this by setting up a voltage divider and measuring the output voltage (Vout) using readadc.
The LED's aren't lighting up properly (some of them light up for some resistors, but there is no clear pattern). When I simulate on PICAXE editor, for both low and high ADC values the LEDs light up, which doesn't make any sense. When ADC is low, there should be more...
***20M PICAXE Ohmmeter Issues***
The LED's aren't lighting up properly (some of them light up for some resistors, but there is no clear pattern). When I simulate on PICAXE editor, for both low and high ADC values the LEDs light up, which doesn't make any sense. When ADC is low, there should be more...
***20M PICAXE Ohmmeter Issues***