Hello.
Enclosed code is one simple example from Bate's book "Interfacing Pic microcontroller".
The codes run properly in Proteus VMS, but not on EasyPic V7 board (to start and stop blinking I use RB1 and 2 buttons in pull up setting). Only RD6 and RD3 are lighted up constantly, but no light sequence like in the simulation.
I had same problems (not running on easypicv7) for other codes with this 16F877A.
I don't know if it is a problem of configuration or so (I remember in the past that to...
PIC16F877A code not running on EASYPIC V7
Enclosed code is one simple example from Bate's book "Interfacing Pic microcontroller".
The codes run properly in Proteus VMS, but not on EasyPic V7 board (to start and stop blinking I use RB1 and 2 buttons in pull up setting). Only RD6 and RD3 are lighted up constantly, but no light sequence like in the simulation.
I had same problems (not running on easypicv7) for other codes with this 16F877A.
I don't know if it is a problem of configuration or so (I remember in the past that to...
PIC16F877A code not running on EASYPIC V7