Hello,
I have trying to download the software through JTAG connector into PCBA, where the PCBA working fine. But, I got an error in the UDE says that the micro-controller is can't able to connect to the UDE.
So, I have investigated on between the PCBA where it is used for software download and another new PCBA, and found that there was a hug resistance between the JTAG pin and GND.
Resistance between JTAG pin and GND is kilo ohms resistance for the PCBA (where it is used for software...
Resistance value difference, why?
I have trying to download the software through JTAG connector into PCBA, where the PCBA working fine. But, I got an error in the UDE says that the micro-controller is can't able to connect to the UDE.
So, I have investigated on between the PCBA where it is used for software download and another new PCBA, and found that there was a hug resistance between the JTAG pin and GND.
Resistance between JTAG pin and GND is kilo ohms resistance for the PCBA (where it is used for software...
Resistance value difference, why?