Hi,
This is my first time working away from Arduino.
I am creating a simple CAN bus analyser using a STM32F105RBT6
I have used parts of circuits from various evaluation boards.
But I am mainly concerned about the Power circuit. I want to be able to power from VIN or USB. Both are to be able to be powered at the same time.
I have also seen similar circuits using a 8mhz or 25mhz so I am not sure which to use.
Will the attached circuit work?
This is my first time working away from Arduino.
I am creating a simple CAN bus analyser using a STM32F105RBT6
I have used parts of circuits from various evaluation boards.
But I am mainly concerned about the Power circuit. I want to be able to power from VIN or USB. Both are to be able to be powered at the same time.
I have also seen similar circuits using a 8mhz or 25mhz so I am not sure which to use.
Will the attached circuit work?